What this is — and what it is not
This is a process walkthrough for a typical 4–6 style soft-tailoring capsule (jackets, trousers, maybe a waistcoat). It is not a published client case. No brand name, order quantity or outcome is claimed here. For how orders actually stage at MANLOR, see the order-stage table.
Gate 0 — Brief gaps that stop the clock
Soft tailoring is unforgiving of a vague brief. The pattern room needs a silhouette reference (garment or photo), a fabric direction with weight, a graded measurement spec or permission to draft one, and destination markets for labelling. Missing any of these does not produce a creative interpretation — it produces a delayed first sample.
- Reference garment or clear photos of hang and shoulder
- Target fabric weight and handfeel (or a swatch)
- Base size and size run
- Whether the jacket is fused, half-canvas or unstructured
Gate 1 — Proto
The first sample proves balance and construction, not the final cloth. Use available cloth that is close in weight when the bulk coating or suiting is still in lab dips. Measure every point of measure against the spec; photograph the hang on a form and a live fit. Soft jackets are judged at the shoulder and lapel roll — numbers alone will not catch a collapsed front.
| Question | If unanswered |
|---|---|
| Does the shoulder sit clean? | Re-cut the block before colourwork |
| Does the lapel roll without bubbling? | Change fusible or canvas before PP |
| Do trousers hang from the waist, not the hip? | Rebalance the block before grading |
| Are POM within tolerance? | See fit and measurement control |
Gate 2 — Fit comments, numbered
Send comments as a numbered list with photos. “Make it more premium” is not actionable. “Shorten body length 1.5 cm at CB; move shoulder seam 0.5 cm forward” is. One or two fit rounds after proto is normal for a new block; a third round usually means the brief changed, not that the factory failed.
Gate 3 — Fabric and trims on the same card
Approve lab dips under agreed light (D65 plus retail). Approve lining, fusible, buttons and thread on the same card as the shell — soft jackets show trim colour at the facing and cuff. Do not seal a PP sample while the button is still “to be confirmed”.
Gate 4 — Size set when grading is new
If the block is new, cut a size set (or at least the smallest and largest sizes) before PP. Soft tailoring grades poorly when chest ease and shoulder pitch were only checked in the base size.
Gate 5 — Seal the PP sample, then stop
The pre-production sample is cut in bulk fabric and trims. Both sides keep a sealed copy. That garment is the standard for bulk and for final inspection. When the calendar slips, the wrong response is to cut bulk against an unsealed proto. The right response is to reseal or to move the ship date.
- Do not cut bulk without a sealed PP
- Do not change fusible after seal without a new seal
- Do not mix dye lots inside one style without a shade-band plan
When not to use this path
If you only need labels and colour on a resolved MANLOR base style, use private label — sealing a new soft-tailoring block is unnecessary cost. If you already hold complete patterns and a graded spec, go OEM with a tech pack and skip ODM design time.
Frequently asked questions
How does a soft-tailoring programme move from brief to sealed sample?
Through fixed gates: a complete brief, a proto that proves hang and construction, numbered fit comments, fabric and trim approvals, a size set when grading is new, and a pre-production sample in bulk fabric and trims sealed by both sides. Bulk cutting waits for that seal.
How many fit rounds are normal for a soft jacket?
One or two after the proto is typical for a new block. A third usually means the silhouette or fabric brief changed.
Can bulk start while lab dips finish?
No. The sealed PP sample must be in the bulk cloth. Cutting against a proto cloth while dips continue is how shade and handfeel fail in the warehouse.